![]() ![]() ![]() Need more help? Ask Krylon or watch our How-To Videos. Krylon Rust Tough dries to the touch in 20 minutes and can be finished with a topcoat after 30 minutes. Rust-Oleum High Performance Wheel Clear Coat is recommended to be applied over Rust-Oleum High Performance Wheel Coatings to provide a high gloss. ![]() Apply multiple thin coats to prevent runs and drips. When all traces of rust are removed, prime the surface with Krylon ® Rust Tough ® with Anti-Rust Technology ™. Priming is an important step that helps create a smooth, consistent surface, increase paint adhesion and decrease the likelihood of color change. Priming and painting after rust has been removed After 24 hours, lightly sand the surface before applying a color topcoat. Rust Tough sprays on clear and dries to a black primer finish. Spray directly over rust to protect against further corrosion. Anything subject to UV rays is going to break down quickly and look. Start with Krylon ® Rust Tough ® Rust Converter, a primer that changes rust to a paintable surface in one easy step. Clear Acrylic or lacquer over rust is fine for indoors but darkens the rust finish severely. If youre worried about it you could wax it from time to time (something that was apparently never done before, hence the clear coat issue). It will take years before the paint breaks down and fades away enough for rust to start forming. You still have paint and primer covering the bare metal. Rust Tough primer dries to the touch in 20 minutes and is tack-free in 15 minutes. It wont rust just because the clear coat is gone. Spray with Krylon ® Rust Tough ® Primer with Anti-Rust Technology ™to eliminate rust and prime the surface. Lightly sand any glossy areas to dull the finish.ĭo not sand old paint that may contain lead.įor more information, contact the National Lead Information Hotline at 1-800-424-LEAD. Making sure the surface is as smooth as possible will help the new paint finish adhere properly. If the surface is rusted or has peeling paint, remove with a wire brush, sandpaper or chemical rust remover. Solvents may soften old paint, causing the new paint to wrinkle or pull away from the surface. The surface should be clean, dull and dry.Īvoid using strong solvents on previously painted surfaces.It holds up OK and is closer than any powdercoat/paint application. For small parts I spray them in a bag, and leave them for a few hours to a day 'marinating' in the fluid, then wipe, and repeat with just a lighter spray. Remove grease or oil with a regionally compliant cleaner. Apply heavy, wipe/work into the metal well, let sit for a few minutes then wipe dry.You can remove most surface grime with ordinary soap and water or household cleaner. Before painting, take the time to properly prepare the surface to ensure that your new paint finish will last.ĭirt, oil and grease can affect the way paint adheres to the surface. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |